How To Repair A Convertible Top Around Rear Window

Download Commodity

Download Article

Modernistic soft convertible car tops often have glass windows glued to the cloth, vinyl or other soft material with a melted plastic strip instead of a clear vinyl window sewn to it. If and when the drinking glass comes unstuck -- sometimes due to the canvas shrinking from neglect or otherwise -- it tin can be very difficult to reattach. Double-sided foam tape such as 3M VHB tape (what one writer used, others could be OK too) tin reattach them, but should be applied in a specific style to avoid abiding strain that volition break its bond.

Steps

1. ane

   Reattach the soft elevation material ("canvas") to the glass when but role of the sheet has detached so that the glass does non accept to be re-centered inside the hole in the canvas. If it does take to be re-centered one might do that by measuring distances with the defrosting grid as a guide and, in any example, holding the glass temporarily in identify with gaffer'due south or other sticky tape.

2. 2

   Open up the top slightly so that information technology is not taut. Prop something such as a small empty box between the front end edge of the superlative and the upper edge of the windshield frame so that the top stays open slightly.

   Advertisement

3. iii

   Observe the seal that was attached but has become unattached, such equally the lower edge of the outside layer of canvas. ^[1] If dirt has accumulated in the pocket that has been exposed to the weather you may wish to vacuum out any large particles.

4. 4

   If only a very small function has separated leave it alone. If a large part is mostly separated yous may wish to split up it entirely to re-seal it every bit ane continuous piece.^[two]

5. five

   Clean the mating surfaces with rubbing alcohol.

6. 6

   Shut the roof completely to encounter where the sheet falls on the drinking glass when pulled gently apartment as far in on the glass equally information technology will go, only not pulled difficult. At least in the case of cotton sheet, this volition probably be non as far up onto the glass as originally (or as on a nonetheless-fastened inside layer) considering it volition have shrunk since new.

7. seven

   Re-open the roof slightly and re-prop it.

8. viii

   Utilize a strip of double-sided foam tape such as 3M VHB ("very high bond")--foam so that it will conform to any irregularities, preferably blackness so ultraviolet rays will not promptly destroy its exposed border--to the glass with the border coming up to the indicate you determined previously. ^[3]

9. ix

   Bring the middle of the area beingness fastened (such as the middle, left-versus-right-wise of the bottom exterior canvas) up to the edge of the record. It should accept just a footling slack, since it needs to be pulled basically shine simply not taut when the acme is closed. Merely a picayune slack when the height is closed is much better than tension, which will unstick the tape.

10. 10

    Stick the sheet to the tape, working outward. The reason to work outward from a central point is so that any "backlog" material does non build upwardly at ane side.^[4]

11. eleven

    Rub downward the canvass over the record firmly and utilize some heat--not a keen painfully hot amount--with a blow dryer for a thorough bail.

    • The convertible peak should be stock-still.

    Advertizement

Add New Question

• Question

  How much will it toll to supersede the peak with the original window?

  

  I take a 2007 Mustang convertible. The window is separating from the cloth top. I went to two convertible top/upholstery shops, and both told me the window is oestrus sealed and the entire top needed to be replaced, and both gave me a cost of $1,900.

• Question

  I have in my garage a Corvette convertible with a canvas pinnacle in bully condition. The seal around the drinking glass rear window has popped, will this procedure work?

  

  I used 3M window weld on our 2004 Volvo C70 elevation and information technology worked groovy! Make sure you become every bit much of the old adhesive off as possible. Put the 3M primer on first and let it dry for near 10 minutes. Put a dewdrop (nearly 3/16) of window weld on it. Clamp it in place. I used some paint stirrer sticks & C clamps. Let it sit for virtually 24 hours. Do not do this if temperature is beneath 40 degrees F.

• Question

  Where can I go 3M VHB cream tape?

  

  Amazon has it in a diverseness of lengths and widths.

• Question

  Tin Gorilla glue be used to attach glass to a convertible canvas top?

  

  No. I tried it and the heat from sitting in the sun made information technology crack and come up apart.

• Question

  How much will it cost to supplant a rear window on a convertible Sebring?

  

  The shops will tell yous a new superlative is needed. Fortunately, the Sebring window lays on top of the canvas flap rather than hanging from it. People swear past Rhino glue for about 20 bucks. I'm planning to remove the window, make clean the unabridged lip that the window edge contacts, put a bead of rhino on it and lay the window back in. Removing it completely volition allow me to position it evenly in the pigsty since the top material has most likely shrunk over the years but if yours is just pulling autonomously in a section you tin open up the height role way and gum the lip while tension is off.

• Question

  Should I glue the inside and the outside of the window?

  

  Brett Gilbert

  Peak Answerer

  Aye, if the sail is loose on the inside function of the window, glue information technology equally well.

• Question

  Where tin I find instructions that are more specific to the type of car I have?

  

  Brett Gilbert

  Top Answerer

  Yous could contact the manufacturer or a mechanic to come across what they recommend. Usually, though, they will tell you to supercede the unabridged hood. The glue or tape techniques piece of work well for simply about any automobile.

Ask a Question

200 characters left

Include your email address to go a message when this question is answered.

Submit

Advertisement

• It may exist better to get the summit stock-still in a fashion for whose possible failure someone else such as a dealer will take responsibility. But this is a corking alternative to replacing the summit.

Advertizement

Things You'll Need

• 3M VHB foam tape, black

Nearly This Article

Thanks to all authors for creating a page that has been read 200,423 times.

Did this article assist you?

Source: https://www.wikihow.com/Reattach-Rear-Window-Glass-to-a-Convertible-Car-Top

Posted by: simpsonmucas1966.blogspot.com

Share this post